Yamaha 02R96 Owner's Manual - Page 41
Power SLOT POWER ON/OFF switch, Grounding screw, AC IN connector, Cooling fan
View all Yamaha 02R96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
28 Chapter 2-Control Surface & Rear Panel Power Section 1 4 2 3 A POWER ON/OFF switch This switch is used to turn on the power to the 02R96. See "Turning On & Off the 02R96" on page 29 for more information. B Grounding screw For electrical safety reasons, and correct operation of the touch-sensitive faders, it's important that the 02R96 is grounded properly. The supplied power cord has a three-pin plug, and if the ground terminal of the AC outlet is grounded, then the unit will be grounded sufficiently through the power cord. If the AC outlet does not provide a suitable ground, this screw must be connected to a suitable ground point. Grounding is also an effective method for eliminating hum, interference, and other noise. C AC IN connector This connector is used to connect the 02R96 to an AC outlet via the supplied power cord. See "Connecting the Power Cord" on page 29 for more information. D Cooling fan The cooling fan expels air out through this outlet. If the airflow is restricted, the 02R96 may overheat, so make sure this outlet is not blocked. SLOT Section 1 A SLOT 1-4 These four slots are for use with optional mini YGDAI cards, which offer a variety of analog and digital I/O options. See "Slot I/O" on page 45 for more information. Slot inputs can be patched to Input Channels or Insert Ins. See "Input Patching" on page 52 for more information. The following signals can be patched to the Slot Outputs: Bus Outs, Aux Sends, Stereo Out, Insert Outs, Direct Outs, and Surround Monitor Channels. See "Output Patching" on page 54 for more information. 02R96-Owner's Manual