Yamaha 02R96 Owner's Manual - Page 180
Assigning Parameters to Control Changes, Controlling Parameters by Using Parameter Changes
View all Yamaha 02R96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
Assigning Parameters to Control Changes 167 Assigning Parameters to Control Changes 02R96 parameters can be assigned to MIDI Control Changes for real-time control. When a parameter is adjusted on the 02R96, the assigned Control Change message is transmitted. Likewise, when a Control Change message is received, the assigned 02R96 parameter is set. You must set the MIDI Setup parameters in order to transmit and receive Control Change messages (see page 165). A Parameter to Control Change assignment table, listing the initial assignments, is provided on page 274. This table can be stored to an external MIDI device, such as a MIDI data filer, by using MIDI Bulk Dump (see page 168). 1 Use the DISPLAY ACCESS [MIDI] button to locate the Control Change Assign Table page. 2 Use the cursor buttons to select the MODE TABLE button, and press [ENTER]. In TABLE mode, when 02R96 parameters are adjusted, MIDI Control Change messages are transmitted in accordance with the assignments on this page. In NRPN mode, when 02R96 parameters are adjusted, predefined NRPNs (Non Registered Parameter Number) are transmitted. 3 Use the cursor buttons to select the CTL CHG. column, and use the Parameter wheel or INC/DEC buttons to select the Control Changes. 4 Use the cursor buttons to select the three PARAMETER columns, and use the Parameter wheel or INC/DEC buttons to select the parameters. Parameters with more than 128 steps require two or more Control Change messages for MIDI transmission and reception. Certain Delay parameters and the faders are divided into L and H parameters. Delay Time parameters are divided into LOW, MID, and HIGH parameters. For accurate transmission, all parameters (e.g., both L and H for faders) must be assigned to individual Control Changes. You can initialize the Parameter to Control Change assignment table by selecting the INITIALIZE button, and then pressing [ENTER]. Controlling Parameters by Using Parameter Changes 02R96 parameters can be controlled in real time by using Parameter Change messages, which are System Exclusive messages. When a parameter is adjusted on the 02R96, a Parameter Change message is transmitted. Likewise, when a Parameter Change message is received, a 02R96 parameter is adjusted. See "MIDI Data Format" on page 275 for detailed information. You must set the MIDI Setup parameters in order to transmit and receive Parameter Change messages (see page 165). 02R96-Owner's Manual