Cisco AIR-LAP1252AG-A-K9 Software Configuration Guide - Page 146
AP Radio Identification for Internal Radio, Step 3
UPC - 882658140716
View all Cisco AIR-LAP1252AG-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Setting Up EAP Authentication Chapter 4 Security Setup Figure 4-9 AP Radio Identification Page for Internal Radio Step 3 Step 4 Step 5 Step 6 Enter the network username you set up for the radio in Step 1 in the LEAP User Name entry field. Enter the network password you set up for the radio in Step 1 in the LEAP Password entry field. Click OK. Follow the steps in the "Enabling EAP on the Access Point" section on page 4-20 to enable Network-EAP on the repeater access point. The next time the repeater reboots, it performs LEAP authentication and associates to the root access point. Note If the repeater access point fails to authenticate because the root access point or the RADIUS server is not set up correctly, you must reboot the repeater access point after correcting the problem. The repeater access point does not attempt to reauthenticate until it reboots. 4-28 Cisco Aironet 1200 Series Access Point Software Configuration Guide OL-2159-03