Cisco AIR-LAP1252AG-A-K9 Software Configuration Guide - Page 57

Chapter 3 Configuration Radio Configuration Radio Configuration This section describes how to configure the access point radios. You use the AP Radio pages in the management system to set the configuration for each radio. The radio pages include: • AP Radio Identification pages-Contain the basic locating and identity information for the access point internal and module radio ports. See the "Entering Identity Information" section on page 3-19 for instructions on using the AP Radio Identification pages. • AP Radio Hardware pages-Contain settings for the access point's SSID, data rates, transmit power, antennas, radio channel, and operating thresholds for the access point internal and module radio ports. See the "Entering Radio Hardware Information" section on page 3-22 for instructions on using the AP Radio Hardware pages. • AP Radio Advanced pages-Contain settings for the operational status of the access point's internal and module radio ports. You can also use these pages to make temporary changes in port status to help with troubleshooting network problems. See the "Entering Advanced Configuration Information" section on page 3-31 for instructions on using the AP Radio Advanced pages. • AP Radio Ports pages-List key information on the access point's radio ports. Entering Identity Information Use the AP Radio Identification pages to enter basic locating and identity information for the access point radios. The internal radio and the radio module both have an AP Radio Identity page. Both pages contain the same settings. Figure 3-10 shows the AP Radio Identification page for the internal radio. OL-2159-03 Cisco Aironet 1200 Series Access Point Software Configuration Guide 3-19