Cisco AIR-LAP1252AG-A-K9 Software Configuration Guide - Page 60

Radio Configuration Chapter 3 Configuration The current IP subnet mask displayed under the setting shows the IP subnet mask currently assigned to the access point. This is the same subnet mask as the default subnet mask unless DHCP or BOOTP is enabled. If DHCP or BOOTP is enabled, this is the subnet mask used by the DHCP or BOOTP server. You can also enter this setting on the Express Setup page. Service Set ID (SSID) The SSID is a unique identifier that client devices use to associate with the access point radio. The SSID helps client devices distinguish between multiple wireless networks in the same vicinity. The SSID can be any alphanumeric entry from two to 32 characters long. You can also enter this setting on the Express Setup page. LEAP User Name Use this field if the radio is set up as a repeater and authenticates to the network using LEAP. When the radio authenticates using LEAP, the access point sends this user name to the authentication server. Follow the steps in the "Setting up a Repeater Access Point as a LEAP Client" section on page 4-27 to set up the radio as a LEAP client. LEAP Password Use this field if the radio is set up as a repeater and authenticates to the network using LEAP. When the radio authenticates using LEAP, the access point uses this password for authentication. Follow the steps in the "Setting up a Repeater Access Point as a LEAP Client" section on page 4-27 to set up the radio as a LEAP client. Entering Radio Hardware Information You use the AP Radio Hardware pages to assign settings related to the access point's radio hardware. The internal radio and the radio module both have an AP Radio Hardware page. Both pages contain similar settings. Figure 3-11 shows the AP Radio Hardware page for the radio module. 3-22 Cisco Aironet 1200 Series Access Point Software Configuration Guide OL-2159-03