Cisco AIR-LAP1252AG-A-K9 Software Configuration Guide - Page 47

Chapter 3 Configuration Filter Setup Click the SNMP link to go to the SNMP Setup page, where you can edit other SNMP settings. You can define other SNMP communities on the Administrator Authorization pages. See the "Setting Up Administrator Authorization" section on page 4-41 for instructions on using the Administrator Authorization pages. Filter Setup This section describes how to set up filtering to control the flow of data through the access point. You can filter data based on protocols and MAC addresses. Each type of filtering is explained in the following sections: • Protocol Filtering, page 3-9 • MAC Address Filtering, page 3-14 Protocol Filtering Protocol filters prevent or allow the use of specific protocols through the access point. You can set up individual protocol filters or sets of filters. You can filter protocols for wireless client devices, users on the wired LAN, or both. For example, an SNMP filter on the access point's radio port prevents wireless client devices from using SNMP with the access point but does not block SNMP access from the wired LAN. Use the Ethernet Protocol Filters page to create and enable protocol filters for the access point's Ethernet port, and use the AP Radio Protocol Filters page to create and enable protocol filters for the access point's radio port. The pages are identical except for the page title. Figure 3-4 shows the main body for the pages. OL-2159-03 Cisco Aironet 1200 Series Access Point Software Configuration Guide 3-9