Dell PowerConnect J-8208 Hardware Guide - Page 137
Unpacking a Line Card Used in a J-EX8200 Switch
View all Dell PowerConnect J-8208 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Chapter 9: Installing Switch Components If the ST LED is unlit, check whether there are enough power supplies installed. See "Calculating Power Requirements for a J-EX8208 Switch" on page 79. If more power supplies are needed, install additional power supplies. See "Installing an AC Power Supply in a J-EX8200 Switch" on page 114. If there are enough power supplies in the switch, remove and install the SF module again. See "Removing an SF Module from a J-EX8208 Switch" on page 169. If the ST LED or the SF LED is lit steady yellow, the SF module has failed. Remove the SF module and install a new one. See "Removing an SF Module from a J-EX8208 Switch" on page 169. Figure 57: Installing an SF Module in a J-EX8208 Switch Related • Removing an SF Module from a J-EX8208 Switch on page 169 Documentation • Switch Fabric (SF) Module in a J-EX8208 Switch on page 25 • SF Module LEDs in a J-EX8208 Switch on page 26 • Packing a Line Card Used in a J-EX8200 Switch on page 202 Unpacking a Line Card Used in a J-EX8200 Switch The line cards for J-EX8200 switches are rigid sheet-metal structures that house the line card components including network ports. The line cards are shipped in a cardboard carton, secured with foam packing material. 121