Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 1000

NOTE: In S5148F-ON, when receive is turned on, it enables decoding of both LLFC and PFC frames on that port. • transmit - (Optional) Indicates the local port can send flow control packets to a remote device. • on - (Optional) When used with receive, allows the local port to receive flow control traffic. When used with transmit, allows the local port to send flow control traffic to the remote device. • off - (Optional) When used with receive, disables the remote device from sending flow control traffic to the local port. When used with transmit, disables the local port from sending flow control traffic to the remote device. Default Command Mode Usage Information Example Disabled (off) INTERFACE The no version of this command returns the value to the default. OS10(conf-if-eth1/1/2)# flowcontrol transmit on Supported Releases 10.3.0E or later hardware deep-buffer-mode Configures Deep Buffer mode. Syntax hardware deep-buffer-mode Parameters None Defaults Disabled Command Modes CONFIGURATION Usage Information Deep Buffer mode configuration takes effect only after you save it in the startup configuration and reboot the switch. The no version of this command disables Deep Buffer mode. Example OS10(config)# hardware deep-buffer-mode Supported Releases 10.4.3.0 or later match Configures match criteria for the QoS policy. Syntax Parameters match {cos cos-number | ip [access-group name name | dscp dscp-value | precedence value] | ipv6 [access-group name name [set dscp dscp-value]] | mac access-group acl-name | not [ip | cos] vlan vlan-id} [set dscp dscp-value] • cos cos-number - Enter a queue number for the CoS match criteria, from 0 to 7. • ip - Enter the IPv4 match criteria. • access-group name name - (Optional) Enter the IPv4 access-group name. • dscp dscp-value - (Optional) Enter a DSCP value for L3 DSCP match criteria, from 0 to 63. • precedence value - (Optional) Enter a precedence value for L3 precedence match criteria, from 0 to 7. • ipv6 - Enter the IPv6 match criteria. 1000 Quality of service