Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 478

Example OS10(conf-router-neighbor-af)# next-hop-self Supported Releases 10.3.0E or later non-deterministic-med Compares paths in the order they arrive. Syntax Parameters Default Command Mode Usage Information non-deterministic-med None Disabled ROUTER-BGP Paths compare in the order they arrive. OS10 uses this method to choose different best paths from a set of paths, depending on the order they are received from the neighbors. MED may or may not be compared between adjacent paths. When you change the path selection from deterministic to non-deterministic, the path selection for the existing paths remains deterministic until you use the clear ip bgp command to clear the existing paths. The no version of this command configures BGP bestpath selection as non-deterministic. NOTE: To configure these settings for a non default VRF instance, you must first enter the ROUTERCONFIG-VRF sub mode using the following commands: 1 Enter the ROUTER BGP mode using the router bgp as-number command. 2 From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example OS10(conf-router-bgp-10)# non-deterministic-med Supported Releases 10.2.0E or later outbound-optimization Enables outbound optimization for IBGP peer-group members. Syntax Parameters Default Command Mode Usage Information outbound-optimization None Not configured ROUTER-BGP Enable or disable outbound optimization dynamically to reset all neighbor sessions. When you enable outbound optimization, all peers receive the same update packets. The next-hop address chosen as one of the addresses of neighbor's reachable interfaces is also the same for the peers. The no version of this command disables outbound optimization. NOTE: To configure these settings for a non default VRF instance, you must first enter the ROUTERCONFIG-VRF sub mode using the following commands: 1 Enter the ROUTER BGP mode using the router bgp as-number command. 2 From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. 478 Layer 3