Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 247

You cannot disable FIP snooping when the port mode is set to a non-default value (enode-transit, fcf, or fcftransit). If you want to change the port mode from one value to another, you can directly use the fip-snooping port mode command. You do not have to explicitly use the no form of the command. The no version of this command resets the port mode to ENode. Example OS10(config)# interface ethernet 1/1/32 OS10(conf-if-eth1/1/32)# fip-snooping port-mode fcf Supported Releases 10.4.0E(R1) or later10.4.3.0 or later-Support for enode-transit and fcf-transit port modes added. FCoE commands The following commands are supported on all the three modes: F_Port, NPG, and FSB. clear fcoe database Clears the FCoE database for the specified VLAN. Syntax clear fcoe database vlan vlan-id {enode enode-mac-address | fcf fcf-mac-address | session fcoe-mac-address} Parameters • vlan-id - Enter the VLAN ID. • enode-mac-address - Enter the MAC address of the ENode. • fcf-mac-address - Enter the MAC address of the FCF. • fcoe-mac-address - Enter the MAC address of the FCoE session. Default Command Mode Usage Information Example Not configured EXEC None OS10# clear fcoe database vlan 100 enode aa:bb:cc:00:00:00 Supported Releases 10.4.0E(R1) or later clear fcoe statistics Clears FCoE statistics for specified interface. Syntax Parameters Default Command Mode Usage Information clear fcoe statistics [interface interface-type] interface-type - (Optional) Enter the interface type. The interface may be ethernet, VLAN, or port-channel. Not configured EXEC If you do not specify the interface interface-type information, the command clears the statistics for all the interfaces and VLANs. Fibre Channel 247