Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 128

Example OS10(config)# ntp source ethernet 1/1/24 Supported Releases 10.2.0E or later ntp trusted-key Sets a key to authenticate the system to which NTP synchronizes with. Syntax ntp trusted-key number Parameters number - Enter the trusted key ID (1 to 4294967295). Default Not configured Command Mode CONFIGURATION Usage Information The number parameter must be the same number as the number parameter in the ntp authenticationkey command. If you change the ntp authentication-key command, you must also change this command. The no version of this command removes the key. Example OS10(config)# ntp trusted-key 234567 Supported Releases 10.2.0E or later show ntp associations Displays the NTP master and peers. Syntax show ntp associations [vrf {management | vrf vrf-name}] Parameters • management - Enter the keyword to display NTP information corresponding to the management VRF instance. • vrf vrf-name - Enter the keyword then the name of the VRF to display NTP information corresponding to that non-default VRF instance. Default Command Mode Usage Information Not configured EXEC • (none) - One or more of the following symbols displays: - * - Synchronized to this peer. - # - Almost synchronized to this peer. - + - Peer was selected for possible synchronization. - - - Peer is a candidate for selection. - ~ - Peer is statically configured. • remote - Remote IP address of the NTP peer. • ref clock - IP address of the remote peer reference clock. • st - Peer stratum, the number of hops away from the external time source. 16 means that the NTP peer cannot reach the time source. • when - Last time the device received an NTP packet. • poll - Polling interval in seconds. • reach - Reachability to the peer in octal bitstream. 128 System management