Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 581

ipv6 ospf passive Configures an interface as a passive interface and suppresses both receiving and sending routing updates to the passive interface. Syntax ipv6 ospf passive Parameters None Default Not configured Command Mode INTERFACE Usage Information You must configure the interface before setting the interface to passive mode. The no version of the this command disables Passive interface configuration. NOTE: As loopback interfaces are implicitly passive, the configuration to suppress sending and receiving of OSPF routing updates does not take effect on the loopback interfaces. However, network information corresponding to these loopback interfaces is still announced in OSPF LSAs that are sent through other interfaces configured for OSPF. Example OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf passive Supported Releases 10.3.0E or later ipv6 ospf priority Sets the priority of the interface to determine the DR for the OSPFv3 network. Syntax Parameters Default Command Mode Usage Information Example ipv6 ospf priority number number - Enter a router priority number, from 0 to 255. 1 INTERFACE When two routers attached to a network attempt to become the DR, the one with the higher router priority takes precedence. The no version of this command resets the value to the default. OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf priority 4 Supported Releases 10.3.0E or later log-adjacency-changes Enables logging of syslog messages about changes in the OSPFv3 adjacency state. Syntax log-adjacency-changes Parameters None Default Disabled Command Mode ROUTER-OSPFv3 Usage Information The no version of this command resets the value to the default. Example OS10(config)# router ospfv3 100 OS10(config-router-ospfv3-100)# log-adjacency-changes Layer 3 581