Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 34

4 Configure the IP addresses on the Management port, where x.x.x.x represents your internal IP address. After you configure the Management port, the response is up. $ ifconfig eth0 x.x.x.x netmask 255.255.0.0 up 5 Install the software on the device. The installation command accesses the OS10 software from the specified SCP, TFTP, or FTP URL, creates partitions, verifies installation, and reboots itself. $ onie-nos-install image_filename location For example, enter ONIE:/ # onie-nos-install ftp://a.b.c.d/PKGS_OS10-Enterprise-x.x.xx.bin Where a.b.c.d represents the location to download the image file from, and x.x.xx represents the version number of the software to install. The OS10 installer image creates several partitions, including OS10-A (active and default) and OS10-B (standby). After installation completes, the switch automatically reboots and loads OS10. Install manually using USB drive You can manually install the OS10 software image using a USB device. Verify that the USB device supports a FAT or EXT2 file system. For instructions to format a USB device in FAT or EXT2 format, see the accompanying Windows documentation for FAT formatting or Linux documentation for FAT or EXT2 formatting. 1 Plug the USB storage device into the USB storage port on the switch. 2 Power up the switch to automatically boot using the ONIE: Rescue option. 3 (Optional) Stop ONIE discovery if the device boots to ONIE: Install. $ onie-discovery-stop 4 Create a USB mount location on the system. $ mkdir /mnt/media 5 Identify the path to the USB drive. $ fdisk -l 6 Mount the USB media plugged in the USB port on the device. $ mount -t vfat usb-drive-path /mnt/media 7 Install the software from the USB, where /mnt/media specifies the path where the USB partition is mounted. $ onie-nos-install /mnt/media/image_file The ONIE auto-discovery process discovers the image file at the specified USB path, loads the software image, and reboots the switch. See the ONIE User Guide for more information. Log into OS10 To log in to OS10 Enterprise Edition, power up the switch and wait for the system to perform a power-on self test (POST). Enter admin for both the default user name and user password. For better security, change the default admin password during the first OS10 login. The system saves the new password for future logins. After you change the password through the CLI, enter the write memory command to save the configuration. OS10 login: admin Password: Last login: Wed Mar 6 07:26:37 UTC 2019 from 10.16.127.145 on pts/0 Linux AG2 4.9.110 #1 SMP Debian 4.9.110-3+deb9u4 x86_64 The programs included with the Debian GNU/Linux system are free software; the exact distribution terms for each program are described in the individual files in /usr/share/doc/*/copyright. Debian GNU/Linux comes with ABSOLUTELY NO WARRANTY, to the extent permitted by applicable law. 34 Getting Started