Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 579

Parameters Default Command Mode Usage Information Example cost - Enter a value as the OSPFv3 cost for the interface, from 1 to 65335. Based on bandwidth reference INTERFACE If not configured, the interface cost is based on the auto-cost command. This command configures OSPFv3 over multiple vendors to ensure that all routers use the same cost value. The no version of this command removes the IPv6 OSPF cost configuration. OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf cost 10 Supported Releases 10.3.0E or later ipv6 ospf dead-interval Sets the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. Syntax ipv6 ospf dead-interval seconds Parameters seconds - Enter the dead interval value in seconds, from 1 to 65535. Default 40 seconds Command Mode INTERFACE Usage Information The dead interval is four times the default hello-interval by default. The no version of this command resets the value to the default. Example OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf dead-interval 10 Supported Releases 10.3.0E or later ipv6 ospf encryption Configures OSPFv3 encryption on an IPv6 interface. Syntax Parameters ipv6 ospf encryption {ipsec spi number esp encryption-type key authenticationtype key | null} • ipsec spi number - Enter a unique security policy index number, from 256 to 4294967295. • esp encryption-type - Enter the encryption algorithm used with ESP (3DES, DES, AES-CBC, or NULL). For AES-CBC, only the AES-128 and AES-192 ciphers are supported. • key - Enter the text string used in the encryption algorithm. • authentication-type - Enter the encryption MD5 or SHA1 authentication algorithm to use. • key - Enter the text string used in the authentication algorithm. • null - Enter the keyword to not use the IPsec encryption. Default Command Mode Usage Information IPv6 OSPF encryption is not configured on an interface. INTERFACE • Before you enable IPsec authentication on an OSPFv3 interface, you must enable IPv6 unicast routing globally, configure an IPv6 address and enable OSPFv3 on the interface, and assign it to an area. • When you configure encryption on an interface, both IPsec encryption and authentication are enabled. You cannot configure encryption if you have already configured an interface for IPsec authentication using the Layer 3 579