Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 157

• If you globally disable a spanning-tree operation, L2 interfaces that are LACP-enabled port-channel members may flap due to packet loops. Add port member - static LAG A static port-channel LAG contains member interfaces that you manually assign using the channel-group mode on command. OS10(config)# interface port-channel 10 Aug 24 4:5:38: %Node.1-Unit.1:PRI:OS10 %dn_ifm %log-notice:IFM_ASTATE_UP: Interface admin state up.:port-channel10 Aug 24 4:5:38: %Node.1-Unit.1:PRI:OS10 %dn_ifm %log-notice:IFM_OSTATE_DN: Interface operational state is down.:port-channel10 OS10(conf-if-po-10)# exit OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# channel-group 10 mode on Aug 24 4:5:56: %Node.1-Unit.1:PRI:OS10 %dn_ifm %log-notice:IFM_OSTATE_UP: Interface operational state is up.:port-channel10 Add port member - dynamic LACP LACP enables ports to dynamically bundle as members of a port-channel. To configure a port for LACP operation, use the channelgroup mode {active|passive} command. Active and Passive modes allow LACP to negotiate between ports to determine if they can form a port channel based on their configuration settings. OS10(config)# interface port-channel 100 OS10(conf-if-po-100)# exit OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# channel-group 100 mode active Minimum links Configure minimum links in a port-channel LAG that must be in oper up status to consider the port-channel to be in oper up status. NOTE: If the minimum links criteria that you have configured is not met, the port channel operationally goes down only in the device in which you have configured the minimum links and not on the device at the other side of the port channel. For the port channel to go down operationally on both sides when the minimum links criteria is not met, you must configure minimum links on both sides of the port channel. Enter the number of links in a LAG that must be in oper up status in PORT-CHANNEL mode, from 1 to 32, default 1. minimum-links number Configure minimum operationally up links OS10(config)# interface port-channel 1 OS10(conf-if-po-1)# minimum-links 5 Assign Port Channel IP Address You can assign an IP address to a port channel and use port channels in L3 routing protocols. • Configure an IP address and mask on the interface in INTERFACE PORT-CHANNEL mode. ip address ip-address/mask [secondary-ip-address] - ip-address/mask - Specify an IP address in dotted-decimal A.B.C.D format and the mask. Interfaces 157