Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 585

Supported Releases 10.3.0E or later show ipv6 ospf interface Displays the configured OSPFv3 interfaces. You must enable OSPFv3 to display the output. Syntax show ipv6 ospf interface interface [vrf vrf-name] Parameters • interface - (Optional) Enter the interface information: - ethernet - Physical interface, from 1 to 48. - port-channel - Port-channel interface, from 1 to 128. - vlan - VLAN interface, from 1 to 4093. • vrf vrf-name - (Optional) Enter the keyword vrf followed by the name of the VRF to display the configured OSPFv3 enabled interfaces in that VRF. Default Command Mode Example Not configured EXEC OS10# show ipv6 ospf interface ethernet1/1/1 is up, line protocol is up Link Local Address fe80::20c:29ff:fe0a:d59/64, Interface ID 5 Area 0.0.0.0, Process ID 200, Instance ID 0, Router ID 10.0.0.2 Network Type broadcast, Cost: 1 Transmit Delay is 1 sec, State BDR, Priority 1 BFD enabled(Interface level) Interval 300 Min_rx 300 Multiplier 3 Role Active Designated Router on this network is 2.2.2.2 Backup Designated router on this network is 10.0.0.2 (local) Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 2.2.2.2(Designated Router) Supported Releases 10.3.0E or later show ipv6 ospf neighbor Displays a list of OSPFv3 neighbors connected to the local router. Syntax show ipv6 ospf [vrf vrf-name] neighbor Parameters • vrf vrf-name - Enter the keyword vrf followed by the name of the VRF to display a list of OSPFv3 neighbors in that VRF. Default Command Mode Usage Information Not configured EXEC • Neighbor ID-Displays the neighbor router ID. • Pri-Displays the priority assigned neighbor. • State-Displays the OSPF state of the neighbor. • Dead Time-Displays the expected time until the system declares the neighbor dead. • Interface ID-Displays the neighbor interface ID • Interface-Displays the interface type, node/slot/port or number information. Example OS10(conf-if-eth1/1/1)# show ipv6 ospf neighbor Neighbor ID Pri State Dead Time Interface ID Interface Layer 3 585