Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 539

View OSPF interface configuration OS10(conf-if-eth1/1/1)# do show ip ospf interface ethernet1/1/1 is up, line protocol is up Internet Address 11.1.1.1/24, Area 0.0.0.0 Process ID 65535, Router ID 99.99.99.99, Network Type broadcast, Cost: 1 Transmit Delay is 200 sec, State BDR, Priority 1 Designated Router (ID) 150.1.1.1, Interface address 11.1.1.2 Backup Designated router (ID) 99.99.99.99, Interface address 11.1.1.1 Timer intervals configured, Hello 5, Dead 20, Wait 20, Retransmit 30 Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 150.1.1.1(Designated Router) Redistribute routes Add routes from other routing instances or protocols to the OSPFv2 process and include BGP, static, or connected routes in the OSPFv2 process. Do not route IBGP routes to OSPFv2 unless there are route-maps associated with the OSPFv2 redistribution. NOTE: With the redistribute static command in the running configuration, if a static route is configured which is also learned through OSPF, even if the static route preference is higher than OSPF, the static route is installed in the routing table. • Enter which routes redistribute into the OSPFv2 process in ROUTER-OSPF mode. redistribute {bgp as-number| connected | static} [route-map map-name] - bgp | connected | static-Enter a keyword to redistribute those routes. - route-map map-name-Enter the name of a configured route map. Configure redistribute routes OS10(conf-router-ospf-10)# redistribute bgp 4 route-map aloha OS10(conf-router-ospf-10)# redistribute connected route-map aloha OS10(conf-router-ospf-10)# redistribute static route-map aloha View OSPF configuration OS10(conf-router-ospf-10)# do show running-configuration ospf ! router ospf 10 redistribute bgp 4 route-map aloha redistribute connected route-map aloha redistribute static route-map aloha ! Default route You can generate an external default route and distribute the default information to the OSPFv2 routing domain. • Generate the default route using the default-information originate [always] command in ROUTER-OSPF mode. Configure default route OS10(config)# router ospf 10 OS10(config-router-ospf-10)# default-information originate always View default route configuration OS10(config-router-ospf-10)# show configuration ! router ospf 10 default-information originate always Layer 3 539