Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 538

Routing Process ospf 65535 with ID 99.99.99.99 Supports only single TOS (TOS0) routes It is an Autonomous System Border Router It is an Area Border Router It is Flooding according to RFC 2328 Convergence Level 1 Min LSA origination 0 msec, Min LSA arrival 0 msec Min LSA hold time 0 msec, Max LSA wait time 0 msec Number of area in this router is 3, normal 1 stub 1 nssa 1 Area BACKBONE (0) Number of interface in this area is 1 SPF algorithm executed 28 times Area ranges are Area (2) Number of interface in this area is 1 SPF algorithm executed 28 times Area ranges are Area (3) Number of interface in this area is 1 SPF algorithm executed 28 times Area ranges are Disable fast convergence OS10(conf-router-ospf-65535)# no fast-converge Interface parameters To avoid routing errors, interface parameter values must be consistent across all interfaces. For example, set the same time interval for the hello packets on all routers in the OSPF network to prevent misconfiguration of OSPF neighbors. 1 To change the OSPFv2 parameters in CONFIGURATION mode, enter the interface. interface interface-name 2 Change the cost associated with OSPF traffic on the interface in INTERFACE mode, from 1 to 65535. The default depends on the interface speed. ip ospf cost 3 Change the time interval, from 1 to 65535, that the router waits before declaring a neighbor dead in INTERFACE mode. The default time interval is 40. The dead interval must be four times the hello interval and must be the same on all routers in the OSPF network. ip ospf dead-interval seconds 4 Change the time interval between hello-packet transmission in INTERFACE mode, from 1 to 65535. The default time interval is 10. The hello interval must be the same on all routers in the OSPF network. ip ospf hello-interval seconds 5 Change the priority of the interface, which determines the DR for the OSPF broadcast network in INTERFACE mode, from 0 to 255. The default priority of the interface is 1. ip ospf priority number 6 Change the retransmission interval time, in seconds, between LSAs in INTERFACE mode, from 1 to 3600. The default retransmission interval time is 5. The retransmit interval must be the same on all routers in the OSPF network. ip ospf retransmit-interval seconds 7 Change the wait period between link state update packets sent out the interface in INTERFACE mode, from 1 to 3600. The default wait period is 1. The transmit delay must be the same on all routers in the OSPF network. ip ospf transmit-delay seconds Change parameters and view interface status OS10(conf-if-eth1/1/1)# ip ospf hello-interval 5 OS10(conf-if-eth1/1/1)# ip ospf dead-interval 20 OS10(conf-if-eth1/1/1)# ip ospf retransmit-interval 30 OS10(conf-if-eth1/1/1)# ip ospf transmit-delay 200 538 Layer 3