Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 112

snmp-server engineID Configures the local and remote SNMP engine IDs. Syntax Parameters snmp-server engineID [local engineID] [remote ip-address {[udp-port portnumber] remote-engineID}] • local engineID - Enter the engine ID that identifies the local SNMP agent on the switch as an octet colon-separated number. A maximum of 27 characters. • remote ip-address - Enter the IPv4 or IPv6 address of a remote SNMP device that accesses the local SNMP agent. • udp-port port-number - Enter the UDP port number on the remote device, from 0 to 65535. • remote-engineID - Enter the engine ID that identifies the SNMP agent on a remote device, 0x followed by a hexadecimal string). Defaults Command Mode Usage Information The local engine ID is generated using the MAC address of the management Ethernet interface. CONFIGURATION The local engine ID is used to generate the localized keys for the authentication and privilege passwords. These passwords authenticate SNMP users and encrypt SNMP messages. If you reconfigure the local Engine ID, the localized keys also change. The existing values are no longer valid and a warning message is displayed. As a result, you must reconfigure SNMP users with new localized password keys. In addition, if you change the configured engine ID for a remote device, you must reconfigure the authentication and privacy passwords for the remote user. To display the current local engine ID, use the show snmp engineID local command. The no version of this command resets the default engine ID values. Example OS10(config)# snmp-server engineID local 80:00:02:b8:04:61:62:63 OS10(config)# snmp-server engineID local 80:00:02:b8:04:61:62:63 % Warning: Localized passwords need to be regenerated for local user. OS10(config)# snmp-server engineID remote 1.1.1.1 0xaaffcc OS10(config)# snmp-server engineID remote 1.1.1.2 udp-port 432 0xabeecc Supported Releases 10.4.2.0 or later snmp-server group Configures the views allowed for the users in an SNMP group. Syntax snmp-server group group-name {v1 | v2c | v3 security-level} [access acl-name] [read view-name] [write view-name] [notify view-name] Parameters • group-name - Enter the name of the group. A maximum of 32 alphanumeric characters. • v1 - SNMPv1 provides no user authentication or privacy protection. SNMP messages are sent in plain text. • v2c - SNMPv2c provides no user authentication or privacy protection. SNMP messages are sent in plain text. 112 System management