Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 182

interface vlan Creates a VLAN interface. Syntax interface vlan vlan-id Parameters vlan-id - Enter the VLAN ID number, from 1 to 4093. Default VLAN 1 Command Mode CONFIGURATION Usage Information FTP, TFTP, MAC ACLs, and SNMP operations are not supported. IP ACLs are supported on VLANs only. The no version of this command deletes the interface. Example OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# Supported Releases 10.2.0E or later link-bundle-utilization Configures link-bundle utilization. Syntax link-bundle-utilization trigger-threshold value Parameters value - Enter the percentage of port-channel bandwidth that triggers traffic monitoring on port-channel members, from 0 to 100. Default Disabled Command Mode CONFIGURATION Usage Information None Example OS10(config)# link-bundle-utilization trigger-threshold 10 Supported Releases 10.2.0E or later mode Configures a front-panel unified port group to operate in Fibre Channel or Ethernet mode, or a QSFP28-DD or QSFP28 port group to operate in Ethernet mode, with the specified speed on activated interfaces. Syntax Parameters mode {Eth {100g-2x | 100g-1x | 50g-2x | 40g-2x | 40g-1x | 25g-8x [fabricexpander-mode] | 25g-4x | 10g-8x | 10g-4x} | FC {32g-4x | 32g-2x | 32g-1x | 16g-4x | 16g-2x | 8g-4x}} • mode Eth - Configure a port group in Ethernet mode and set the speed to: - 100g-2x - Split a QSFP28-DD port into two 100GE interfaces. - 100g-1x - Reset a QSFP28 port group to 100GE mode. - 50g-2x - Split a QSFP28 port into two 50GE interfaces. - 40g-2x - Split a port group into two 40GE interfaces. - 40g-1x - Set a port group to 40G mode for use with a QSFP+ 40GE transceiver. 182 Interfaces