Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 383

Default Command Mode Usage Information Example local CONFIGURATION The no version of this command removes the monitor session. OS10(config)# monitor session 1 OS10(conf-mon-local-1)# Example (RPM) OS10(config)# monitor session 5 type rpm-source OS10(conf-mon-rpm-source-5)# Example (ERPM) OS10(config)# monitor session 10 type erpm-source OS10(conf-mon-erpm-source-10)# Supported Releases 10.2.0E or later show monitor session Displays information about a monitoring session. Syntax show monitor session {session-id | all} Parameters • session-id - Enter the session ID number, from 1 to 18. • all - View all monitoring sessions. Default Command Mode Usage Information Example (specific session) All EXEC In the State field, true indicates that the port is enabled. In the Reason field, Is UP indicates that hardware resources are all OS10# show monitor session 1 S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Protocol 1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 Example (all sessions) OS10# show monitor session all S.Id Source Destination Dir Mode Source IP Dest IP DSCP TTL Gre-Prot 1 ethernet1/1/1 remote-ip both port 11.11.11.1 11.11.11.11 0 255 35006 9 ethernet1/1/9 both port N/A N/A N/A 7 ethernet1/1/9 vlan40 both port N/A N/A N/A 4 ethernet1/1/1 both port N/A N/A 0 255 35006 Destination is not resolved 6 ethernet1/1/2 remote-ip both port 11.11.11.1 2.2.2.1 0 255 35006 session does not exist Supported Releases 10.2.0E or later shut Disables the monitoring session. The monitoring session can be: local, RPM, or ERPM. Syntax shut Parameters None Layer 2 383