Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 1109

iscsi priority-bits Resets the priority bitmap advertised in iSCSI application TLVs. Syntax Parameter Default Command Mode Usage Information Example iscsi priority-bits {priority-bitmap} priority-bitmap - Enter a bitmap value for the dot1p priority advertised for iSCSI traffic in iSCSI application TLVs (0x1 to 0xff). 0x10 (dot1p 4) CONFIGURATION iSCSI traffic uses dot1p priority 4 in frame headers by default. Use this command to reconfigure the dot1p-priority bits advertised in iSCSI application TLVs. Enter only one dot1p-bitmap value - setting more than one bitmap value with this command is not supported. The default dot1p 4 value advertises only if you enabled PFC pause frames for dot1p 4 traffic using the pfc-cos dot1p-priority command. The no version of this command resets to the default value. OS10(config)# iscsi priority-bits 0x20 Supported Releases 10.3.0E or later iscsi profile-storage Configures a port for direct connection to a storage device that is not automatically detected by iSCSI. Syntax iscsi profile-storage storage-device-name Parameter storage-device-name - Enter a user-defined name of a storage array that iSCSI does not automatically detect. Default Not configured Command Mode INTERFACE Usage Information Configure directly attached storage arrays that iSCSI supports if they are not automatically detected. This command is required for storage devices that do not support LLDP. The no version of this command disables the connection. Example OS10(conf-if-eth1/1/2)# iscsi profile-storage compellant Supported Releases 10.3.0E or later iscsi session-monitoring enable Enables iSCSI session monitoring. Syntax iscsi session-monitoring enable Parameter None Default Disabled Command Mode CONFIGURATION Converged data center services 1109