Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 54

no shutdown ipv6 enable ipv6 address autoconfig ! support-assist ! policy-map type application policy-iscsi ! class-map type application class-iscsi Show difference between candidate and running configurations OS10# show diff candidate-configuration running-configuration OS10# NOTE: If the show command does not return output, the candidate-configuration and running-configuration files match. Prevent configuration changes You can prevent configuration changes on sessions other than the current CLI session using the lock command. To respectively prevent and allow configuration changes on other sessions, use the lock and unlock commands in EXEC mode. When you enter the lock command on a CLI session, users cannot make configuration changes across any other active CLI sessions. When you close the CLI session where you entered the lock command, configuration changes are automatically allowed on all other sessions. Lock configuration changes OS10# lock Unlock configuration changes OS10# unlock Change to transaction-based configuration mode To change to Transaction-Based Configuration mode for a session, enter the start transaction command. 1 Change to Transaction-Based Configuration mode in EXEC mode. start transaction 2 Enable, for example, an interface from INTERFACE mode. interface ethernet 1/1/1 no shutdown 3 Save the configuration. do commit NOTE: After you enter the do commit command, the current session switches back to the default behavior of committing all configuration changes automatically. Save configuration changes manually OS10# start transaction OS10# configure terminal OS10(config)# OS10(config)# interface ethernet 1/1/1 OS10(config-if-eth1/1/1)# no shutdown OS10(config-if-eth1/1/1)# do commit 54 Getting Started