Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 175

Interface commands channel-group Assigns an interface to a port-channel group. Syntax channel-group channel-number mode {active | on | passive} Parameters • channel-number - Enter a port-channel number, from 1 to 128. • mode - Sets LACP Actor mode. • active - Sets Channeling mode to Active. • on - Sets Channeling mode to static. • passive - Sets Channeling mode to passive. Default Command Mode Usage Information Example Not configured INTERFACE The no version of this command resets the value to the default, and unassigns the interface from the port-channel group. OS10(config)# interface ethernet 1/1/2:1 OS10(conf-if-eth1/1/2:1)# channel-group 20 mode active Supported Releases 10.3.0E or later default vlan-id Reconfigures the VLAN ID of the default VLAN. Syntax Parameters Default Command Mode Usage Information Example default vlan-id vlan-id vlan-id - Enter the default VLAN ID number, from 1 to 4093. VLAN1 CONFIGURATION By default, VLAN1 serves as the default VLAN for switching untagged L2 traffic on OS10 ports in Trunk or Access mode. If you use VLAN1 for network-specific data traffic, reconfigure the VLAN ID of the default VLAN. The command reconfigures the access VLAN ID, the default VLAN, of all ports in Switchport Acess mode. Ensure that the VLAN ID exists before configuring it as the default VLAN. OS10(config)# default vlan-id 10 OS10(config)# do show running-configuration ... ! interface vlan1 no shutdown ! interface vlan10 no shutdown ! interface ethernet1/1/1 Interfaces 175