Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 302

Usage Information Example This command enables LLDP globally for all Ethernet PHY interfaces, except on those interfaces where you manually disable LLDP. The no version of this command disables LLDP globally irrespective of whether you manually disable LLDP on an interface. OS10(config)# lldp enable Supported Releases 10.3.1E or later lldp holdtime-multiplier Configures the multiplier value for the hold time in seconds. Syntax lldp holdtime-multiplier integer Parameters integer - Enter the holdtime-multiplier value in seconds, from 2 to 10. Default 4 seconds Command Mode CONFIGURATION Usage Information Hold time is the amount of time in seconds that a receiving system waits to hold the information before discarding it. Formula: Hold Time = (Updated Frequency Interval) X (Hold Time Multiplier). The no version of this command resets the value to the default. Example OS10(config)# lldp holdtime-multiplier 2 Supported Releases 10.2.0E or later lldp med fast-start-repeat-count Configures the number of packets sent during the activation of the fast start mechanism. Syntax lldp-med fast-start-repeat-count number Parameters number - Enter the number of packets sent during the activation of the fast start mechanism, from 1 to 10. Default 3 Command Mode CONFIGURATION Usage Information None Example OS10(config)# lldp med fast-start-repeat-count 5 Supported Releases 10.2.0E or later lldp med Enables or disables LLDP-MED on an interface. Syntax Parameters lldp med {enable | disable} • enable - Enable LLDP-MED on the interface. • disable - Disable LLDP-MED on the interface. Default Enabled with network-policy TLV 302 Layer 2