Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 1132

A sensor group defines the data that is collected and streamed to a destination. Use any of the pre-configured sensor groups to monitor system resources. To display the sensor paths for each group, use the show telemetry sensor-group command. Table 78. Pre-configured sensor group Pre-configured sensor group BGP BGP-peer Buffer Device Environment Interface LAG (port channel) System Minimum sampling interval (milliseconds) 15000 0 15000 15000 15000 15000 0 15000 Configure a destination group A destination group defines the destination servers to which streaming telemetry data is sent. 1 Enter the destination group name in TELEMETRY mode. A maximum of 32 characters. OS10(conf-telemetry)# destination-group group-name 2 Enter the IPv4 or IPv6 address and transport-service port number in DESTINATION-GROUP mode. Only one destination is supported in the 10.4.3.0 release. You can enter a fully qualified domain name (FQDN) for ip-address. The destination domain name resolves to an IP address - see System domain name and list. OS10(conf-telemetry-dg-dest)# destination ip-address port-number 3 Return to TELEMETRY mode. OS10(conf-telemetry-dg-dest)# exit Configure a subscription profile A subscription profile associates destination groups and sensor groups, and specifies the data encoding format and transport protocol. 1 Enter the subscription profile name in TELEMETRY mode. A maximum of 32 characters. OS10(conf-telemetry)# subscription-profile profile-name 2 Enter the name of a pre-configured sensor group and sampling interval in SUBSCRIPTION-PROFILE mode. Valid sensor-group names are: bgp, bgp-peer, buffer, device, environment, interface, lag, and system. To view the data contents of a preconfigured sensor group, use the show telemetry sensor-group command. The interface sensor group supports only physical and port-channel interfaces. The sampling interval is in milliseconds, from 0 (whenever an event occurs; near real-time) to 4294967295. The default is 15000. Repeat this step to add sensor groups to the subscription profile. OS10(conf-telemetry-sp-subscription)# sensor-group group-name sampling-interval 3 Enter the name of a destination group in SUBSCRIPTION-PROFILE mode. Telemetry data is sent to the IP address and port specified in the destination group. Repeat this step to add destination groups to the subscription profile. OS10(conf-telemetry-sp-subscription)# destination-group name 4 Enter the source interface in SUBSCRIPTION-PROFILE mode. The system uses the source interface to derive the VRF instance and IP address used to communicate with destination devices. For gRPC transport, source interface configuration is optional. OS10(conf-telemetry-sp-subscription)# source interface Where interface is one of the following values: • ethernet node/slot/port[:subport] - Enter a physical Ethernet interface. • loopback number - Enter a Loopback interface, from 0 to 16383. 1132 Telemetry