Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 524

Parameters • reachable-time milliseconds - Enter the reachable time in milliseconds, from 0 to 3600000. Defaults Command Mode Usage Information Example 0 INTERFACE The no version of this command restores the default reachable time. 0 indicates that no reachable time is sent in RA messages. OS10(config)# interface ethernet 1/2/3 OS10(conf-if-eth1/2/3)# ipv6 nd reachable-time 1000 Supported Releases 10.4.0E(R1) or later ipv6 nd retrans-timer Sets the time between retransmitting neighbor solicitation messages. Syntax ipv6 nd retrans-timer seconds Parameters • retrans-timer seconds - Enter the retransmission time interval in milliseconds, from 100 to 4292967295. Defaults Command Mode Usage Information Example Not configured INTERFACE The no version of this command disables the configured retransmission timer. OS10(config)# interface ethernet 1/2/3 OS10(conf-if-eth1/2/3)# ipv6 nd retrans-timer 1000 Supported Releases 10.4.0E(R1) or later ipv6 nd send-ra Enables sending ICMPv6 RA messages. Syntax ipv6 nd send-ra Parameters None Defaults RA messages are disabled. Command Mode INTERFACE Usage Information • Using ICMPv6 RA messages, the Neighbor Discovery Protocol (NDP) advertises the IPv6 addresses of IPv6enabled interfaces and learns of any address changes in IPv6 neighbors. Before you enable sending RA messages, the switch must be in Router mode with IPv6 forwarding enabled and stateless autoconfiguration disabled no ipv6 address autoconfig command. • The no version command disables RA messages. Example OS10(config)# interface ethernet 1/2/3 OS10(conf-if-eth1/2/3)# ipv6 nd send-ra Supported Releases 10.4.0E(R1) or later 524 Layer 3