Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 783

Configuration after reload: OS10# show hardware l3 Current Settings IPv6 Extended Prefix Entries: 2048 Next-boot Settings 2048 The no version of the command removes the IPv6 extended prefix route configuration. Save and Reload the switch to remove the configuration. OS10(config)# no hardware l3 ipv6-extended-prefix % Warning: Un-configuring IPv6 Extended Prefix will be applied only after a save and reload. UFT commands hardware forwarding-table mode Selects a mode to initialize the maximum scalability size. The available options are: scaled L2 MAC address table, scaled L3 routes table, or scaled L3 hosts table. Syntax Parameters hardware forwarding-table mode {scaled-l2 | scaled-l3-routes | scaled-l3-hosts} • scaled-l2 -Enter the L2 MAC address table size. • scaled-l3-routes - Enter the L3 routes table size. • scaled-l3-hosts - Enter the L3 hosts table size. Defaults Command Mode Usage Information The default parameters vary according to the platform. See UFT modes. CONFIGURATION Configure the sizes of internal L2 and L3 forwarding tables for your requirements of the network environment. To apply the changes, reload the switch. The no version of this command resets the UFT mode to default. Example OS10(config)# hardware forwarding-table mode scaled-l3-hosts Supported Releases 10.3.0E or later hardware l3 ipv6-extended-prefix Configures the maximum number of route entries for IPv6 extended prefix route. Syntax Parameters Defaults Command Mode Usage Information Example hardware l3 ipv6-extended-prefix prefix-number prefix-number -Enter the maximum number of route entries for IPv6 extended prefix route. The options available are: 1024, 2048, or 3072. None CONFIGURATION Save and Reload the switch for the settings to become effective. The no version of the command removes the IPv6 extended prefix route configuration. OS10# configure terminal OS10(config)# hardware l3 ipv6-extended-prefix 2048 UFT modes 783