Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 1008

qos-group dot1p Configures a dot1p trust map to the traffic class. Syntax qos-group tc-list [dot1p values] Parameters • qos-group tc-list - Enter the traffic single value class ID, from 0 to 7. • dot1p values - (Optional) Enter either single, comma-delimited, or a hyphenated range of dot1p values, from 0 to 7. Default Command Mode Usage Information Example 0 TRUST-MAP If the trust map does not define dot1p values to any traffic class, those flows map to the default traffic class 0. If some of the dot1p values are already mapped to an existing traffic class, you see an error. You must have a 1:1 dot1p-to-traffic class mapping for PFC-enabled CoS values. You must also have a common dot1p trust map for all interfaces using DCB. The no version of this command returns the value to the default. OS10(conf-tmap-dot1p-qos)# qos-group 5 dot1p 5 Supported Releases 10.3.0E or later qos-group dscp Configures a DSCP trust map to the traffic class. Syntax qos-group tc-list [dscp values] Parameters • qos-group tc-list - Enter the traffic single value class ID, from 0 to 7. • dscp values - (Optional) Enter either single, comma-delimited, or a hyphenated range of DSCP values, from 0 to 63. Default Command Mode Usage Information Example 0 TRUST-MAP If the trust map does not define DSCP values to any traffic class, those flows map to the default traffic class 0. If some of the DSCP values are already mapped to an existing traffic class, you will see an error. The no version of this command returns the value to the default. OS10(conf-tmap-dscp-qos)# qos-group 5 dscp 42 Supported Releases 10.3.0E or later qos-rate-adjust Configures additional number of data bytes to add to overhead fields per frame for rate calculations. Syntax qos-rate-adjust [value-of-adjust] Parameters value-of-adjust-Number of bytes to add to overhead fields in each frame, from 1 to 31. 1008 Quality of service