Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 390

Assign an interface back to the default VRF instance Table 17. Configurations to be removed CONFIGURATION MODE IP address - In interface configuration INTERFACE CONFIGURATION mode, undo the IP address configuration. Port - In interface configuration mode, INTERFACE CONFIGURATION remove the interface association corresponding to the VRF instance that you want to delete. COMMAND OS10(conf-if-eth1/1/10:1)#no ip address ipv4-address or no ipv6 address ipv6- address OS10(conf-if-eth1/1/10:1)#no ip vrf forwarding To assign an interface back to the default VRF, perform the following steps: 1 Enter the interface that you want to assign back to the default VRF instance. CONFIGURATION interface ethernet 1/1/1 2 Remove the IPv4 address associated with the interface. INTERFACE CONFIGURATION no ip address 3 Remove the IPv6 address associated with the interface. INTERFACE CONFIGURATION no ipv6 address 4 Assign the interface back to the default VRF instance. INTERFACE CONFIGURATION no ip vrf forwarding Assigning the management interface back to the default VRF instance To assign the management interface back to the default VRF, perform the following steps: 1 Enter the management VRF instance. CONFIGURATION ip vrf management 2 Assign the management interface back to the default VRF instance. CONFIGURATION VRF no interface management Deleting a non-default VRF instance Before deleting a non-default VRF instance, ensure all the dependencies and associations corresponding to that VRF instance are first removed or disabled. Following table shows the dependencies that you have to remove before deleting a non-default VRF instance: After removing all dependences, you can delete the non-default VRF instances that you create. 390 Layer 3