Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 1078

clear ufd-disable Overrides the uplink-state group configuration and brings up the downstream interfaces. Syntax clear ufd-disable {interface interface-type | uplink-state-group group-id} Parameters • interface-type - Enter the interface type. • group-id - Enter the uplink state group ID, from 1 to 32. Default Command Mode Usage Information Example None EXEC This command manually brings up a disabled downstream interface that is in an UFD-disabled error state. After the downstream interface is up, it is not disabled until there are changes in the upstream interfaces. This command does not affect downstream interfaces that are already up or interfaces that are not part of the UFD group. OS10# clear ufd-disable interface ethernet 1/1/2 OS10# clear ufd-disable uplink-state-group 1 Supported Releases 10.4.0E(R3) or later defer-time Configures the timer to defer UFD actions on downstream ports. Syntax Parameters Default Command Mode Usage Information Example defer-time timer timer- Enter the timer value in seconds, ranging from 1 to 120. Disabled UPLINK-STATE-GROUP You can view configured timer details using the show uplink-state-group [group-id] detail command. The no version of this command disables the timer. OS10(config)# uplink-state-group 1 OS10(conf-uplink-state-group-1)# defer-time 120 Supported Releases 10.4.1.0 or later downstream Adds an interface or a range of interfaces as a downstream interface to the uplink-state group. Syntax downstream {interface-type | interface-range} Parameters • interface-type - Enter the interface type as Ethernet or port-channel. • interface-range - Enter the range of interfaces. Default None 1078 Uplink Failure Detection