Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 804

disable Lowers the privilege level. Syntax disable privilege-level Parameters • privilege-level-Enter the privilege level, from 0 to 15. Defaults Command Mode Usage Information 1 Privileged EXEC If you do not specify a privilege level, the system assigns level 1. Example OS10# disable OS10# disable 6 Supported Releases 10.4.3.0 or later enable Enables a specific privilege level. Syntax Parameters enable privilege-level • privilege-level-Enter the configured privilege level, from 0 to 15. Defaults Command Mode Usage Information 15 Exec Dell EMC Networking recommends configuring a password for privilege level 15 using the enable password command. If you do not configure a password for a level, you can switch to that level without entering a password, unless a password is configured for a highest intermediate level. If you configure a password for an intermediate level, enter that password when prompted. To access privilege level 15, you must configure the enable password command. If you do not configure a password for privilege level 15, you cannot enter level 15. For privilege levels 0 to 14, the enable password command is optional. Privilege levels inherit all permitted commands from all lower levels. For example, if you log in to privilege level 10 using the enable 10 command, all commands that are assigned to privilege level 10 and lower are available for use. Example OS10# enable OS10# enable 10 Supported Releases 10.4.3.0 or later 804 Security