Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 774

controller ovsdb Changes the mode to CONFIGURATION-NVE-OVSDB from where you can configure the controller parameters. Syntax Parameters Default Command mode Usage information controller ovsdb None None CONFIGURATION-NVE The controller configuration initiates the OVSDB service on the OS10 switch. The no version of this command stops the OVSDB service. The no version command fails if any ports are configured as controller-managed ports or IP address configuration. NOTE: Before removing the controller configuration from the device, you must delete all controllermanaged ports and IP address configuration. Example OS10(config)# nve OS10(config-nve)# controller ovsdb Supported releases 10.4.3.0 or later ip port ssl Configures the OVSDB controller reachability information such as IP address, port number, and the connection type of session, in the switch. Syntax Parameters ip ip-address port port-number ssl • ip-address - Specify the IP address of the OVSDB controller to connect with. • port-number - Specify the port number through which the connection to the OVSDB controller is made. Default For an OVSDB-based controller, configure the following: • Port number as 6640 • Connection type as SSL Command mode Usage information CONFIGURATION-NVE-OVSDB Currently, the only supported OVSDB controller is the NSX controller. no version of this command removes the connection to the OVSDB controller. Example OS10(config)# nve OS10(config-nve)# controller ovsdb OS10(config-nve-ovsdb)# ip 10.11.66.110 port 6640 ssl Supported releases 10.4.3.0 or later 774 VXLAN