Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 597

Match clauses: ip address (access-lists): acl1 Set clauses: ip vrf red next-hop 1.1.1.1 track-id 200 Sample configuration Consider a scenario where traffic from source IP address 1.1.1.1 ingresses through VLAN40 that is part of VRF RED. The egress interface for this traffic is also on the same VRF RED with IP address 4.4.4.4, as shown. Using the following PBR configuration, you can re-direct traffic ingresssing to VRF RED to a destination that is reachable through the nexthop IP address 2.2.2.2 in VRF BLUE: 1 Create a route-map. OS10(config)# route-map test 2 Enter the IP address to match the specified access list. OS10(config-route-map)# match ip 4.4.4.4 acl1 3 Set the next-hop address to 2.2.2.2, which is reachable through VRF BLUE. OS10(config-route-map)# OS10(config-route-map)# set ip vrf BLUE next-hop 2.2.2.2 OS10(config-route-map)# exit 4 Apply this rule to the interface where the traffic ingresses, in this case VLAN40. OS10(config)# interface vlan 40 OS10(conf-if-vl-40)# OS10(conf-if-vl-40)# ip policy route-map test 5 (Optional) View the PBR configuration on the interface. OS10(conf-if-vl-40)# show configuration ! interface vlan40 no shutdown ip policy route-map test ! Track route reachability Track IPv4 or IPv6 reachablility using object tracking. To configure tracking over the routes that are reachable through a VRF instance: 1 Configure object tracking. Layer 3 597