HP P Class 450/500/550/600/650/700/750 HP Visualize x- and p-Class (733,800, 8 - Page 116
Removing the I/O Card, Replacing the Bulkhead Blank
View all HP P Class 450/500/550/600/650/700/750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
Opening Your Personal Workstation and Installing Accessories Installing and Removing Accessory Boards Figure 2-79 3. Remove the I/O card from the I/O connector on the system board. Note that you should lift upward on the I/O card's bulkhead and its opposite edge. See Figure 2-79. Removing the I/O Card Figure 2-80 4. Place your I/O card in its anti-static bag making sure you are wearing the static-grounding strap that was shipped with your I/O card. 5. Replace the bulkhead blank as shown in Figure 2-80. Replacing the Bulkhead Blank T-15 Torx Screw Bulkhead 116 Chapter 2
116
Chapter 2
Opening Your Personal Workstation and Installing Accessories
Installing and Removing Accessory Boards
3.
Remove the I/O card from the I/O connector on the system board.
Note that you should lift upward on the I/O card’s bulkhead and its
opposite edge. See Figure 2-79.
Figure 2-79
Removing the I/O Card
4.
Place your I/O card in its anti-static bag making sure you are wearing
the static-grounding strap that was shipped with your I/O card.
5.
Replace the bulkhead blank as shown in Figure 2-80.
Figure 2-80
Replacing the Bulkhead Blank
Bulkhead
T-15 Torx
Screw