Icom VE-PG4 Operating Guide ver.1.36 - Page 146

6 Transceiver Controller Profile screen Transceiver Controller > Common Settings > Profile ■■ Profile 6 7 8 9 10 11 6 Controller IP Address Notify Enter the IP address or host name of the controller that is selected as the server of IP100H. Enter an IP address or host name of up to 63 characters. LLIf you use the RoIP Gateway as a server, you must not set this item. 7 Registration Interval ��� Enter the transmit interval for the registration information that the IP100Hs will use. (Default: 60) •• Range: 30 ~ 300 (seconds) in 1 second steps LLGenerally use the default setting. LLWhen the interval period is short, and an IP100H goes out of the communication area, the IP100H registration on the RoIP Gateway can be updated earlier. Therefore, if the IP100H receives an Individual call, the RoIP Gateway can quickly reply "No response" as a Target availability check. 8 Registration Retry Interval (If failed Enter a retry interval when the IP100H fails to register to the RoIP Gateway. (Default: 10) •• Range: 1 ~ 30 (seconds) 9 Number of Registration Retries (If failed Enter a number of registration retries if the IP100H fails to register to the RoIP Gateway. (Default: 2) •• Range: 1 ~ 10 10 Expire Time The RoIP Gateway check the IP100Hs connection status in this interval.  (Default: 180) •• Range: [Registration Interval] (7) setting +1 ~ 900 (seconds) LLGenerally use the default setting. LLYou cannot set this setting to shorter than the [Registration Interval] (7) setting. 11 Calling Notice Tone ��� Select a notice tone for calling.  (Default: Tone 1) •• Options: Not Use, or Tone 1 ~ Tone 8 LLThis tone can be individually assigned to each call type, "Individual Call," "Group Call," "All Call," and "Telephone." 6-75