Icom VE-PG4 Operating Guide ver.1.36 - Page 182
Transceiver Control , Transceiver Model: IC-SAT100, Connection Notice Tone
View all Icom VE-PG4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
7 Connection Port Settings EXT I/O (EXT) screen Connection Port Settings > EXT I/O (EXT) ■■Transceiver Control Transceiver Model: IC-SAT100 These items are displayed when "Transceiver" is selected as a connected unit. (Connection Port Settings > EXT I/O (EXT) > EXT I/O Port Mode > EXT I/O 1 ~ 4 > Connected Unit) (Connection Port Settings > EXT I/O (EXT) > EXT I/O > EXT I/O Port) Edit the control settings for transceivers connected to the EXT1 ~ EXT4 ports. These items are displayed only when "Connection Unit" is set to "Transceiver." 1 2 3 4 LL4 is displayed only when 3 is set to Enable. 1 TX Volume Adjust the RoIP Gateway's transmitting audio level that is sent to the connected transceiver. (Default: 0) •• Range: -12 ~ +6 (dB) 2 RX Volume Adjust the RoIP Gateway's audio output level of the audio signal that is received from the connected transceiver. (Default: 0) •• Range: -12 ~ +6 (dB) 3 Connection Notice Tone � Select Whether or not to notify the connection status (success or failure) to the IC-SAT100 to the caller transceiver (only in the full-duplex communication) with a notification tone. (Default: Disable) When enabling this item, the caller transceiver can receive a notification tone while holding down [PTT]. The RoIP Gateway alerts as a failure when: •• The RoIP Gateway could not connect to the IC-SAT100. •• The IC-SAT100 could not connect to any satellites. 4 Connection Notice Tone Volume Adjust the Connection Notice Tone audio level that is sent to the source transceiver. (Default: 0) •• Range: -12 ~ +6 (dB) 7-28