Icom VE-PG4 Operating Guide ver.1.36 - Page 363
Control, Settings > Bridge Connection > AMBE+2 Vocoder Assignment >
![]() |
View all Icom VE-PG4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 363 highlights
13 PBX Extension Converter Bridge screen PBX Extension > Converter Bridge ■■Control The settings for the communication control between the RoIP gateway and a Converter Bridge connection destination. 1 2 3 4 5 6 7 8 9 10 11 1 Prioritized Receive ��� 2 PTT Call Cancel on Call Incoming 3 Target Availability Check � 4 Timing of Target Availability Check Select "Enable" to inhibit a SIP phone from transmitting an RTP signal while it is receiving an RTP signal from a Converter Bridge connection destination. (Default: Disable) Select "Enable" to cancel the current call if a SIP phone receives another call from the same Converter Bridge connection destination while a call is incoming. (Default: Disable) Displayed only when the voice protocol setting on the Converter Bridge is set to "Bridge Protocol" or "Protocol for Transceiver and SIP Phone connection" in the "AMBE+2 Vocoder Assignment." (Bridge Connection Settings > Bridge Connection > AMBE+2 Vocoder Assignment > Converter Bridge 1 ~ 20) Select whether or not to check the availability of a Converter Bridge connection destination when a device such as SIP phone linked to this RoIP gateway makes a call (excluding an emergency call) to it. If this setting is enabled, the RoIP gateway will stop sending a call to a linked transceiver when the destination transceiver is busy, or it does not answer in 5 seconds. (Default: Enable) Set when the Target Availability Check (3) will occur. (Default: After Call) •• After Call: Checks after a call is established •• Prior to Call: Checks before a call is established 13-65
![](/manual_guide/products/icom-vepg4-operating-guide-ver136-0267382/363.png)