Icom VE-PG4 Operating Guide ver.1.36 - Page 52

4 Router Settings VPN screen Router Settings > VPN ■■IPsec Tunnel Settings Set the virtual private network (VPN) connection using the IPsec tunnel. 1 2 3 4 5 6 7 8 9 10 1 Tunnel Interface 2 Tunnel 3 Tunnel Name 4 Interface 5 Authentication Key (Pre-Shared Key 6 Remote Address Specifying the interface to register the IPsec tunnel. Range: vti0 ~ vti31 Select "Enable" to use the IPsec tunnel to register. (Default: Enable) Select "Disable" when it is registered but not used. Enter the name to identify the IPsec tunnel of up to 31 characters. Select the interface to connect with Remote Address. (Default: eth0) ••eth0 Select this interface when "Static IP" or "DHCP client" is set in the "Connection Type" setting (Router Settings > WAN > Connection Type). ••ppp0(WAN01) ~ ppp7(WAN08) Select this interface when "PPPoE(WAN01 ~ WAN08)" is set in the "Connection Type" setting (Router Settings > WAN > Connection Type). LL"WAN01 ~ WAN08" are the nicknames. To authenticate the VPN Remote peer, enter the same character strings as the connected device of up to 128 alphanumeric characters. Enter the IP address or the host name of the VPN connection destination. When the IP address or the host name is entered, the RoIP Gateway initiates a VPN connection to the connected device. LLIf this item is not set, the RoIP Gateway only works as a responder that waits for a connection from other devices. 4-25