Icom VE-PG4 Operating Guide ver.1.36 - Page 74
RoIP Settings screen, Additional Controller Settings
View all Icom VE-PG4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
6 Transceiver Controller RoIP Settings screen Transceiver Controller > RoIP Settings ■■Additional Controller Settings Configure the Additional Controller Settings. You can communicate with the IP100Hs and the IP100FS that are registered to additional controllers. 1 2 1 Controller Mode 2 Service Port Number �� Select "Master" for one Master Controller. Select "Sub" for the other Controllers (up to 10 Sub Controllers can be set up). (Default: Sub) When several Controllers are linked, and use All call or Group call between the controllers, set a controller as shown below. •• Sub: One Master Controller can be set up. •• Master: Up to 10 Sub Controllers can be set up. Enter the port number for receiving audio signals. (Default: 32000) •• Range: "1024" ~ "65534" (only even numbers) The port number (RTP) and the port number +1 (RTCP) are used for communication. LLThis number is also used for the caller port number. LLDo not set a port number that has already been used by another connection setting. 6-3