Icom VE-PG4 Operating Guide ver.1.36 - Page 220
Transceiver Control
![]() |
View all Icom VE-PG4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
7 Connection Port Settings RoIP Gateway screen Connection Port Settings > RoIP Gateway ■■Transceiver Control The control settings for the Transceiver connected to the RoIP Gateway 1 ~ 8 port. LLDisplayed when the Mode of the selected RoIP Gateway port is set to "Transceiver." 1 2 3 4 LL4 is displayed only when 3 is set to Enable. 56 1 TX Volume Set the transceiver's transmitting audio level. •• Range: -12 (minimum) ~ +6 (maximum) (dB) (Default: 0) 2 RX Volume Set the transceiver's receiving audio level. •• Range: -12 (minimum) ~ +6 (maximum) (dB) (Default: 0) 3 Connection Notice Tone � Select Whether or not to notify the connection status (success or failure) to the transceiver connected to the RoIP Gateway to the caller with a notice tone. (Default: Disable) When enabling this item, a caller can receive a notification tone during ringing. The RoIP Gateway alerts as a failure when: •• The connection status is other than "Connected." (C onnection Port Settings > RoIP Gateway > Transceiver Connection > Connection Status) •• The IC-SAT100M could not connect to any satellites. 4 Connection Notice Tone Volume Adjust the Connection Notice Tone audio level that is sent to the source transceiver. (Default: 0) •• Range: -12 ~ +6 (dB) 5
![](/manual_guide/products/icom-vepg4-operating-guide-ver136-0267382/220.png)