Icom VE-PG4 Operating Guide ver.1.36 - Page 186
PTT Control Setting, Release Time
View all Icom VE-PG4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
7 Connection Port Settings EXT I/O (EXT) screen Connection Port Settings > EXT I/O (EXT) ■■PTT Control Setting These items are displayed when "Transceiver" is selected as a connected unit (except for the Transceiver Model is set to "IC-SAT100.") (Connection Port Settings > EXT I/O (EXT) > EXT I/O Port Mode > EXT I/O 1 ~ 4 > Connected Unit) (Connection Port Settings > EXT I/O (EXT) > EXT I/O > EXT I/O Port) Edit the PTT control settings. 1 2 3 4 LL1 and 4 are displayed only when Connection Unit is set to "Transceiver," Transceiver Model is set to "General Setting," and PTT Control is set to "VOX." LL2 and 3 are displayed only when Connection Unit is set to "Transceiver." 1 Attack Time Set the TX Attack time to between 5 and 500 milliseconds. It is the delay time before the VOX switch turns ON after an audio signal is received through the network. (Default: 50) 2 Release Time Set the RX Delay time. It is the delay time for the VOX switch to turn OFF after no audio signal is received through the network. (Default: 500) LLWhen the PTT Control in [Transceiver Control] is set to "RTP," the default value is "200." •• Range: 5 ~ 2000 (milliseconds) 3 Voice Delay Enter the amount of time to store the audio, in 5 millisecond steps. (Default: 200) LLWhen the PTT Control in [Transceiver Control] is set to "RTP," the default value is "300." •• Range: 0 ~ 1500 (milliseconds) 4 VOX Threshold Enter the voice threshold level. •• Range: 0 ~ 100 (%) (Default: 40) 7-32