Icom VE-PG4 Operating Guide ver.1.36 - Page 353
Default: RTP, Select the PTT-OFF tone when any signal types shown above
![]() |
View all Icom VE-PG4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 353 highlights
13 PBX Extension Transceiver Controller Telephone Connection screen PBX Extension > Transceiver Controller Telephone Connection ■■ Control 11 12 13 14 15 16 17 18 19 20 LL"PTT-ON Tone" (18) and "PTT-OFF Tone" (19) are displayed only when any PTT Control Types from "Group Call/All Call" (11) to "Individual Call to a Microphone" (17) are set to "DTMF." 18 PTT-ON Tone 19 PTT-OFF Tone 20 Method Select the PTT-ON tone when any signal types shown above (11 ~ 17) is set to "DTMF." (Default: 0) •• Range: 0 ~ 9, *, or # LLDial this number on the SIP phone to make a destination device start transmitting. LLIf you enter the same value in both the PTT-ON Tone and the PTT-OFF Tone, you can toggle the destination device status by dialing this number. Select the PTT-OFF tone when any signal types shown above (11 ~ 17) is set to "DTMF." (Default: 0) •• Range: 0 ~ 9, *, or # LLDial this tone on the SIP phone to make the destination device to stop transmitting. LLIf you enter the same value in both the PTT-ON Tone and PTT-OFF Tone, you can toggle the destination device status by dialing this number. Set the transmitting trigger to make a call from a transceiver controller to the IP telephone system. (Default: RTP) •• VOX: Starts dialing when the VOX detects voice data in the voice packet that is received by the bridge interface through the RTP (Real-time Transport Protocol). •• RTP: Starts dialing when the RTP (voice data packet) is longer than the set period time in the Attack Time setting is received, regardless of if the RTP includes voice data or not. 13-55
![](/manual_guide/products/icom-vepg4-operating-guide-ver136-0267382/353.png)