Icom VE-PG4 Operating Guide ver.1.36 - Page 362

13 PBX Extension Converter Bridge screen PBX Extension > Converter Bridge ■■Communication The settings to communicate between the RoIP gateway and a converter bridge connection destination. 1 2 3 4 5 6 LLThe screen shows when both Encryption and Talkback are enabled. 1 Encryption 2 TalkBack 3 Call Type 4 Dstination Prefix ID ��� 5 Destination ID 6 Source ID Select "Enable" to encrypt the communication.  (Default: Disable) When you select "Enable," enter the appropriate key in "Encryption Key." •• Range: 1 ~ 32767 LLThis setting takes effect when the AMBE+2 codec is used. Commonly used by the transceivers that belong to a group set in the RoIP Gatway. Set the period of time from when the transceiver finishes transmitting until the screen returns to the standby mode.  (Default: 5) •• Range: 1 ~ 10 (seconds) Set the call type to send from a SIP phone to a transceiver that belongs to the Converter Bridge connection destination. (Default: Group) •• Options: Individual, Group, or All Enter the prefix ID of the destination. •• Range: Blank or 0 ~ 30 LLThe range differs, depending on the system settings (Default: Blank) Does not displayed when the Call Type (3) is set to "All." Enter an Individual ID or Group ID of the destination transceiver, that is entered into the Converter Bridge connection destination. (Default: 1) •• Range: When the Prefix is not set: 1 ~ 9999999 When the Prefix is set: 1 ~ 99999 Enter an Individual ID or Group ID of the caller. This ID will be announced at the call destination. •• Range: 1 ~ 9999999 (Default: 1) 13-64