Intermec PX4i PX4i and PX6i High Performance Printer User's Manual - Page 121

Chapter 4 - Troubleshooting and Maintaining the Printer Understanding Error Messages Use the following tables to troubleshoot common error messages you may see displayed on your printer's screen. Keep in mind that some error messages: • are specific to the type of firmware you are running. • have corresponding error numbers. • cause the Intermec Ready-to-Work indicator to blink or turn off. Fingerprint Error Messages Message Description Ready-to-Work Error Indicator Status Number Out of paper The printer is out of paper. Load a new roll of media. Blinking For help, see "Loading Media" on page 7. Next label not Next label not found found Blinking Label not taken Label not taken Blinking Out of transfer ribbon The printer is out of transfer ribbon. Load a new roll Blinking of ribbon. For helps, see "Loading Ribbon" on page 43. Transfer ribbon is installed This is not an error condition. This message briefly Blinking appears after a new roll of transfer ribbon is installed. Head lifted The printhead is lifted. Lower the printhead. Blinking Cutter does Open and shut the cutter. not respond Blinking Cutter error1 Open and shut the cutter. Blinking Cutter error2 Open and shut the cutter. Blinking Cutter error3 Open and shut the cutter. Blinking Cutter open Shut the cutter. LSS too high This error can occur when you run a test feed Blinking without any media installed, or if you have incorrect media settings. Load the printer with media and select the appropriate media type. For help, see "Loading Media" on page 7. 1005 1031 1027 1058 1022 1059 1701 1702 1703 1704 1007 PX4i and PX6i High Performance Printer User's Manual 107