Intermec PX4i PX4i and PX6i High Performance Printer User's Manual - Page 124

Chapter 4 - Troubleshooting and Maintaining the Printer IPL Error Messages Message Description Ready-to-Work Error Indicator Status Number Paper Out The printer is out of paper. Load a new roll of media. Blinking For help, see "Loading Media" on page 7. Ribbon Out The printer is out of transfer ribbon. Load a new roll Blinking of ribbon. For helps, see "Loading Ribbon" on page 43. Ribbon Fitted This is not an error condition. This message briefly Blinking appears after a new roll of transfer ribbon is installed. Printhead Up The printhead is lifted. Lower the printhead. Blinking Open & Shut Cutter error 1. Open and shut the cutter. Cutter Blinking Open & Shut Cutter error 2. Open and shut the cutter. Cutter Blinking Open & Shut Cutter error 3. Open and shut the cutter. Cutter Blinking Paper Fault LSS too high. This error can occur when you run a test feed without any media installed, or if you have incorrect media settings. Load the printer with media and select the appropriate media type. For help, see "Loading Media" on page 7. Blinking Paper Fault LSS too low. This error can occur when you run a test feed without any media installed, or if you have incorrect media settings. Load the printer with media and select the appropriate media type. For help, see "Loading Media" on page 7. Blinking Paper Fault Press Feed The printer did not perform a test feed before it Blinking printed out test labels. Performing a test feed calibrates the sensor. To perform a testfeed, press the A button. Press the F button to resume. Blinking Paused This is not an error condition. This message appears Blinking when the print job is paused. Setup mode entered. Off IP link error. No network connection. Blinking 1005 1031 1027 1058 1022 1059 1701 110 PX4i and PX6i High Performance Printer User's Manual