Intermec PX4i PX4i and PX6i High Performance Printer User's Manual - Page 38

Chapter 1 - Using the Printer 17 Close the front door and media cover. 18 Press F to advance the media and adjust the media feed. Loading Media for Cut-Off Printing You can install the automatic paper cutter option to cut off the media. Cut-off printing can be used for non-adhesive continuous stock and self-adhesive labels with liner (cut only liner between labels). The cutter option: • is designed for paper-based media with a thickness between 60 and 175 μm, roughly corresponding to a paper weight of 60 to 175 grams/m2 (basis weight 40 to 120 lb). • cuts through the media approximately 37 mm (1.5 in) in front of the printer's dot line. Make sure to properly adjust the media feed. For help, see "Configuring Your Printer" on page 74. • should not be used to cut through labels, because the adhesive sticks to the shears, which can damage the cutter. If you do cut through adhesive labels, tilt the cutter down and clean it with isopropyl alcohol. • must be enabled in Setup mode. For help, see "Configuring Your Printer From the Screen" on page 74. • is held by a latch inside the media compartment and can be tilted forward to facilitate loading media. 24 PX4i and PX6i High Performance Printer User's Manual