Intermec PX4i PX4i and PX6i High Performance Printer User's Manual - Page 98
Understanding the General Network Settings, Setting, Description, Configuring the Printer - firmware update
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Chapter 3 - Configuring the Printer Use the following table to understand the general network settings. Understanding the General Network Settings Setting Printer Name System Location System Contact Set Password Old Admin Password New Admin Password Restrictions Description The network identification name (WINS name) of the printer. The default name is INTERMEC followed by the last six positions of the MAC address. (Optional) The printer location. (Optional) The printer administrator. You must check this box if you want to change the admin password. You need to enter the old password before you can change the password. The new password you want to use. Sets restrictions on who is allowed to upgrade the printer firmware or view and change network settings. You cannot remove "admin" from the list of authorized users. Users allowed to update: Defines who may perform a firmware upgrade using FTP, PrintSet, or IFAB. This setting does not affect upgrading from a Compact Flash card. Users allowed to read/write protected LAN1 settings: (Fingerprint only) Defines who may read/ write settings in the LAN1 section. Users allowed to change network settings: (Fingerprint only) Defines who may change the network node in the setup. This setting is not supported if you are setting up the printer from its internal keyboard. Users allowed to change wireless settings: Defines who may change WLAN or 802.1x settings. 84 PX4i and PX6i High Performance Printer User's Manual