Intermec PX4i PX4i and PX6i High Performance Printer User's Manual - Page 80
Can Be Off, Leap, Peap, Ttls, Or Eap-fast
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Chapter 2 - Connecting the Printer 3 Send these commands to configure the EAP_TYPE: setup "8021x","EAP_TYPE","xxxx" where xxxx can be OFF, LEAP, PEAP, TTLS, or EAP-FAST. setup "8021x",".EAP_USER","xxxx" setup "8021x","EAP_PASS","xxxx" where xxxx is the unique username and the unique password for this protocol. 4 If you are using TTLS, you may need to send this command to set the TTLS outer name: setup "8021x","TTLS_USER","xxxx" where xxxx is the outer name. 5 If you are using EAP-FAST, you can use PAC and ACQUIRE_PAC commands. The PAC setting specifies the PAC file to use for EAPFAST authentication. The ACQUIRE_PAC setting checks to see if automatic PAC file provisioning is enabled. You can set ACQUIRE_PAC to on or off. • Send the following command to set PAC to use /tmp/my.pac with a pass phrase of "verysecret": setup "8021x","PAC","/tmp/my.pac@verysecret" • Send the following command to set ACQUIRE_PAC to on: setup "8021x","ACQUIRE_PAC","ON" 6 If you are using certificates for validation, here are some commands you may need to use. • Send the following commands to set a certificate and enable validation: setup "8021x","CA_CERT","c:/test.pfx@export" setup "8021x","VALIDATE","ON" where c:/test.pfx is the location and name of the certificate on the printer and export is the passphrase. 66 PX4i and PX6i High Performance Printer User's Manual