Intermec PX4i PX4i and PX6i High Performance Printer User's Manual - Page 122
Fingerprint Error Messages continued, Troubleshooting and Maintaining the Printer - calibration
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Chapter 4 - Troubleshooting and Maintaining the Printer Fingerprint Error Messages (continued) Message Description Ready-to-Work Error Indicator Status Number LSS too low This error can occur when you run a test feed Blinking without any media installed, or if you have incorrect media settings. Load the printer with media and select the appropriate media type. For help, see "Loading Media" on page 7. Testfeed not done The printer did not perform a test feed before it Blinking printed out test labels. Performing a test feed calibrates the sensor. To perform a testfeed, press the A button. No RFID support installed The optional RFID interface is not installed in the Blinking printer. No tag found No RFID tag has been found. Blinking Pause Mode The print job is paused. Entered Blinking Setup Mode The printer is in Setup mode. Off Entered IP link error No network connection. Blinking IP The printer is trying to acquire an IP address from configuration the network. Wait for the printer to complete the error task before taking any action. Blinking Generic DP error In Direct Protocol, you can enable error handling for Blinking specific errors using the ERROR statement. When errors added to the built-in error handling occur, this event is set. The text included in the SNMP trap is the standard text corresponding to the error. Press any key If an error occurs in the Fingerprint immediate Off to continue mode, for example "out of paper" when the print key is pressed, this event is set. Application load error If an application is started but does not run, the Intermec Ready-to-Work indicator blinks. For example, if there is a syntax error in the loaded program file. Blinking RtW blink by This condition is set by the Fingerprint SYSHEALTH Blinking application command. For more information, see the Intermec Fingerprint Command Reference Manual. 1008 1606 1320 1321 108 PX4i and PX6i High Performance Printer User's Manual